ORCID Profile
0000-0002-4062-0322
Current Organisation
University of Washington
Does something not look right? The information on this page has been harvested from data sources that may not be up to date. We continue to work with information providers to improve coverage and quality. To report an issue, use the Feedback Form.
Publisher: American Meteorological Society
Date: 28-01-2016
Abstract: Strong, mesoscale tip jets and barrier winds that occur along the southeastern Greenland coast have the potential to impact deep convection in the Irminger Sea. The self-organizing map (SOM) training algorithm was used to identify 12 wind patterns that represent the range of winter [November–March (NDJFM)] wind regimes identified in the fully coupled Regional Arctic System Model (RASM) during 1990–2010. For all wind patterns, the ocean loses buoyancy, primarily through the turbulent sensible and latent heat fluxes haline contributions to buoyancy change were found to be insignificant compared to the thermal contributions. Patterns with westerly winds at the Cape Farewell area had the largest buoyancy loss over the Irminger and Labrador Seas due to large turbulent fluxes from strong winds and the advection of anomalously cold, dry air over the warmer ocean. Similar to observations, RASM simulated typical ocean mixed layer depths (MLD) of approximately 400 m throughout the Irminger basin, with in idual years experiencing MLDs of 800 m or greater. The ocean mixed layer deepens over most of the Irminger Sea following wind events with northerly flow, and the deepening is greater for patterns of longer duration. Seasonal deepest MLD is strongly and positively correlated to the frequency of westerly tip jets with northerly flow.
Publisher: International Glaciological Society
Date: 2015
Abstract: This work evaluates the fidelity of the polar marine Ekman layer in the Regional Arctic System Model (RASM) and Community Earth System Model (CESM) using sea-ice inertial oscillations as a proxy for ice-ocean Ekman transport. A case study is presented that demonstrates that RASM replicates inertial oscillations in close agreement with motion derived using the GPS. This result is obtained from a year-long case study pre-dating the recent decline in perennial Arctic sea ice, using RASM with sub-hourly coupling between the atmosphere, sea-ice and ocean components. To place this work in context, the RASM coupling method is applied to CESM, increasing the frequency of oceanic flux exchange from once per day in the standard CESM configuration, to every 30 min. For a single year simulation, this change causes a considerable increase in the median inertial ice speed across large areas of the Southern Ocean and parts of the Arctic sea-ice zone. The result suggests that processes associated with the passage of storms over sea ice (e.g. oceanic mixing, sea-ice deformation and surface energy exchange) are underestimated in Earth System Models that do not resolve inertial frequencies in their marine coupling cycle.
Publisher: Copernicus GmbH
Date: 18-06-2018
Publisher: Copernicus GmbH
Date: 23-06-2016
Abstract: Abstract. This paper describes the first version of a stand-alone runoff routing tool, mizuRoute. The mizuRoute tool post-processes runoff outputs from any distributed hydrologic model or land surface model to produce spatially distributed streamflow at various spatial scales from headwater basins to continental-wide river systems. The tool can utilize both traditional grid-based river network and vector-based river network data. Both types of river network include river segment lines and the associated drainage basin polygons, but the vector-based river network can represent finer-scale river lines than the grid-based network. Streamflow estimates at any desired location in the river network can be easily extracted from the output of mizuRoute. The routing process is simulated as two separate steps. First, hillslope routing is performed with a gamma-distribution-based unit-hydrograph to transport runoff from a hillslope to a catchment outlet. The second step is river channel routing, which is performed with one of two routing scheme options: (1) a kinematic wave tracking (KWT) routing procedure and (2) an impulse response function – unit-hydrograph (IRF-UH) routing procedure. The mizuRoute tool also includes scripts (python, NetCDF operators) to pre-process spatial river network data. This paper demonstrates mizuRoute's capabilities to produce spatially distributed streamflow simulations based on river networks from the United States Geological Survey (USGS) Geospatial Fabric (GF) data set in which over 54 000 river segments and their contributing areas are mapped across the contiguous United States (CONUS). A brief analysis of model parameter sensitivity is also provided. The mizuRoute tool can assist model-based water resources assessments including studies of the impacts of climate change on streamflow.
Publisher: American Geophysical Union (AGU)
Date: 02-2019
DOI: 10.1029/2018WR023903
Publisher: American Meteorological Society
Date: 26-08-2016
Abstract: The Regional Arctic System Model (RASM) is a fully coupled, regional Earth system model applied over the pan-Arctic domain. This paper discusses the implementation of the Variable Infiltration Capacity land surface model (VIC) in RASM and evaluates the ability of RASM, version 1.0, to capture key features of the land surface climate and hydrologic cycle for the period 1979–2014 in comparison with uncoupled VIC simulations, reanalysis datasets, satellite measurements, and in situ observations. RASM reproduces the dominant features of the land surface climatology in the Arctic, such as the amount and regional distribution of precipitation, the partitioning of precipitation between runoff and evapotranspiration, the effects of snow on the water and energy balance, and the differences in turbulent fluxes between the tundra and taiga biomes. Surface air temperature biases in RASM, compared to reanalysis datasets ERA-Interim and MERRA, are generally less than 2°C however, in the cold seasons there are local biases that exceed 6°C. Compared to satellite observations, RASM captures the annual cycle of snow-covered area well, although melt progresses about two weeks faster than observations in the late spring at high latitudes. With respect to derived fluxes, such as latent heat or runoff, RASM is shown to have similar performance statistics as ERA-Interim while differing substantially from MERRA, which consistently overestimates the evaporative flux across the Arctic region.
Publisher: Copernicus GmbH
Date: 18-06-2018
DOI: 10.5194/GMD-2018-104
Abstract: Abstract. The Regional Arctic System Model version 1 (RASM1) has been developed to provide high-resolution simulations of the Arctic atmosphere-ocean-sea ice-land system. Here, we provide a baseline for the capability of RASM to simulate interface processes by comparing retrospective simulations from RASM1 for 1990–2014 with the Community Earth System Model version 1 (CESM1) and the spread across three recent reanalyses. Evaluations of surface and 2-m air temperature, surface radiative and turbulent fluxes, precipitation, and snow depth in the various models and reanalyses are performed using global and regional datasets and a variety of in situ datasets, including flux towers over land, ship cruises over oceans, and a field experiment over sea ice. These evaluations reveal that RASM1 simulates precipitation that is similar to CESM1, reanalyses, and satellite-gauge combined precipitation datasets over all river basins within the RASM domain. The possible reasons for this result are discussed. Snow depth in RASM is closer to upscaled surface observations over a flatter region than in more mountainous terrain in Alaska. The sea ice interface is well simulated in regards to radiation fluxes which generally fall within observational uncertainty. RASM1 surface temperature and radiation biases are shown to be due to biases in the simulated mean diurnal cycle. Development of RASM2 aims to address these biases.
Publisher: Elsevier BV
Date: 07-2003
Publisher: Copernicus GmbH
Date: 04-12-2018
Abstract: Abstract. The Regional Arctic System Model version 1 (RASM1) has been developed to provide high-resolution simulations of the Arctic atmosphere–ocean–sea ice–land system. Here, we provide a baseline for the capability of RASM to simulate interface processes by comparing retrospective simulations from RASM1 for 1990–2014 with the Community Earth System Model version 1 (CESM1) and the spread across three recent reanalyses. Evaluations of surface and 2 m air temperature, surface radiative and turbulent fluxes, precipitation, and snow depth in the various models and reanalyses are performed using global and regional datasets and a variety of in situ datasets, including flux towers over land, ship cruises over oceans, and a field experiment over sea ice. These evaluations reveal that RASM1 simulates precipitation that is similar to CESM1, reanalyses, and satellite gauge combined precipitation datasets over all river basins within the RASM domain. Snow depth in RASM is closer to upscaled surface observations over a flatter region than in more mountainous terrain in Alaska. The sea ice–atmosphere interface is well simulated in regards to radiation fluxes, which generally fall within observational uncertainty. RASM1 monthly mean surface temperature and radiation biases are shown to be due to biases in the simulated mean diurnal cycle. At some locations, a minimal monthly mean bias is shown to be due to the compensation of roughly equal but opposite biases between daytime and nighttime, whereas this is not the case at locations where the monthly mean bias is higher in magnitude. These biases are derived from errors in the diurnal cycle of the energy balance (radiative and turbulent flux) components. Therefore, the key to advancing the simulation of SAT and the surface energy budget would be to improve the representation of the diurnal cycle of radiative and turbulent fluxes. The development of RASM2 aims to address these biases. Still, an advantage of RASM1 is that it captures the interannual and interdecadal variability in the climate of the Arctic region, which global models like CESM cannot do.
Publisher: American Geophysical Union (AGU)
Date: 04-2015
DOI: 10.1002/2015WR017200
Publisher: American Meteorological Society
Date: 08-2017
Abstract: The near-surface climate, including the atmosphere, ocean, sea ice, and land state and fluxes, in the initial version of the Regional Arctic System Model (RASM) are presented. The sensitivity of the RASM near-surface climate to changes in atmosphere, ocean, and sea ice parameters and physics is evaluated in four simulations. The near-surface atmospheric circulation is well simulated in all four RASM simulations but biases in surface temperature are caused by biases in downward surface radiative fluxes. Errors in radiative fluxes are due to biases in simulated clouds with different versions of RASM simulating either too much or too little cloud radiative impact over open ocean regions and all versions simulating too little cloud radiative impact over land areas. Cold surface temperature biases in the central Arctic in winter are likely due to too few or too radiatively thin clouds. The precipitation simulated by RASM is sensitive to changes in evaporation that were linked to sea surface temperature biases. Future work will explore changes in model microphysics aimed at minimizing the cloud and radiation biases identified in this work.
Publisher: Copernicus GmbH
Date: 02-11-2015
Abstract: Abstract. This paper describes the first version of a stand-alone runoff routing tool, mizuRoute, which post-processes runoff outputs from any distributed hydrologic model or land surface model to produce spatially distributed streamflow at various spatial scales from headwater basins to continental-wide river systems. The tool can utilize both traditional grid-based river network and vector-based river network data, which includes river segment lines and the associated drainage basin polygons. Streamflow estimates at any desired location in the river network can be easily extracted from the output of mizuRoute. The routing process is simulated as two separate steps. The first is hillslope routing, which uses a gamma distribution to construct a unit-hydrograph that represents the transport of runoff from a hillslope to a catchment outlet. The second step is river channel routing, which is performed with one of two routing scheme options: (1) a kinematic wave tracking (KWT) routing procedure and (2) an impulse response function–unit hydrograph (IRF-UH) routing procedure. The mizuRoute system also includes tools to pre-process spatial river network data. This paper demonstrates mizuRoute's capabilities with spatially distributed streamflow simulations based on river networks from the United States Geological Survey (USGS) Geospatial Fabric (GF) dataset, which contains over 54 000 river segments across the contiguous United States (CONUS). A brief analysis of model parameter sensitivity is also provided. The mizuRoute tool can assist model-based water resources assessments including studies of the impacts of climate change on streamflow.
Publisher: Elsevier BV
Date: 07-2003
Publisher: American Geophysical Union (AGU)
Date: 04-2015
DOI: 10.1002/2015WR017198
Publisher: American Geophysical Union (AGU)
Date: 03-2017
DOI: 10.1002/2016JC012323
No related grants have been discovered for Bart Nijssen.