ORCID Profile
0000-0002-6119-8423
Current Organisation
Chalmers tekniska högskola
Does something not look right? The information on this page has been harvested from data sources that may not be up to date. We continue to work with information providers to improve coverage and quality. To report an issue, use the Feedback Form.
Publisher: American Chemical Society (ACS)
Date: 16-10-2020
DOI: 10.26434/CHEMRXIV.13102247
Abstract: Herein we present arabinoxylan (AX)-based thermoplastics obtained by ring opening oxidation and subsequent reduction (dA-AX) combined with hydrophobization with three different glycidyl ethers [n-butyl (BuGE), isopropyl (iPrGE) and 2-ethylhexyl (EtHGE) glycidyl ether]. We also present the relationship of structural composition, thermal processing and thermomechanical properties. The BuGE and iPrGE etherified dA-AXs showed glass transition temperatures (T sub g /sub ) far below their degradation temperatures and gave thermoplastic materials when compression-molded at 140˚C. The BuGE (3 mole) etherified dA-AX films at 19 and 31 % oxidation levels exclusively exhibit 244 % (±42) and 267 % (±72) elongation. In contrast, iPrGE-dA-AX s les with shorter and branched terminals in the side chains had maximum 60 % (±19) elongation. The dramatic difference in elongation is assumed to be due to the presence of longer alkoxide chains, higher molar substitution and dual T sub g /sub for the BuGE s les. Such superior elongation of AX thermoplastic films and its relationship with molar substitution and T sub g /sub has not been reported before.
Publisher: Elsevier BV
Date: 12-2018
DOI: 10.1016/J.CARBPOL.2018.08.110
Abstract: Hemicellulose from pulp mill process water and crop residuals from food production often end up in waste streams or burnt for energy contribution. These waste products contain valuable biopolymers but lack many attributes needed for use in applications such as food and medical or consumer products. This study reports on an investigation of the periodate oxidation of hardwood xylan and arabinoxylan (AX) from wheat bran to produce materials with new functionalities. The study explores how to control the oxidation degree and describes structural differences between the two xylan-based polymers. For the xylan s les, the oxidation resulted in a lowering of the glass transition temperature (T
Publisher: Elsevier BV
Date: 2019
DOI: 10.1016/J.CARBPOL.2018.09.062
Abstract: Hemicelluloses are a relatively unused renewable resource. One reason is their broad structure variety that makes it hard to understand structure-property relations. In this study arbinoxylan, extracted from barley husk, was chemically modified into hydroxypropyl methyl-, hydroxypropyl- and methyl arabinoxylan. The relationship between structure and phase behavior was investigated by using multivariate analysis. The arabinoxylan ethers were characterized using mid-infrared FTIR spectroscopy and from principal components analysis, PCA, structural or physical variations between s les were visualized. With orthogonal projections to latent structures, OPLS, vibrations specific for arabinoxylan hydroxypropyl and methyl substitutions was assigned. Among the observed differences between chemical derivatives was an intensity change in the water vibration. The differences in hydration were related to clouding phase behavior of the arabinoxylan ethers. This study shows that multivariate analysis methods are useful for finding unexpected and/or hidden features in the polysaccharide structure.
Publisher: American Chemical Society (ACS)
Date: 19-10-2020
DOI: 10.26434/CHEMRXIV.13102772
Abstract: Valorization of argi-waste polymers into value-added materials is essential for sustainable development of polymeric industry. Reported herein is a 1-step and 2-step strategy for fabrication of flexible and stretchable thermoplastics prepared by compression molding from two structurally different arabinoxylans (AX). The synthesis was accomplished using n-butyl glycidyl ether whose epoxide ring opened on hydroxyl group and resulted in introduction of alkoxide sidechains for the 1-step synthesis. AX was preactivated by periodate oxidation as 1st step for the 2-step synthesis. Two structurally different AXs, i.e. wheat bran extracted arabinoxylan (AXWB, araf/xylp=3/4) and barley husk extracted arabinoxylan (AXBH, araf/xylp=1/4) were used to understand the effects of the araf/xylp on thermoplastic properties because melt processability has been rare for low araf/xylp AXs. AXBH-derived s les demonstrated melt compression processability. AXWB and AXBH derived thermoplastics featured dual and single glass transition (Tg) characteristics respectively as confirmed by DSC and DMA, but AXBH derived thermoplastics had lower stretchability (maximum 160%) compared to AXWB s les (maximum 300 %). Higher araf/xylp and thus in turn longer alkoxide side chains in AXWB derived thermoplastics explained differences in stretchability. / / /
Publisher: American Chemical Society (ACS)
Date: 19-10-2020
DOI: 10.26434/CHEMRXIV.13102772.V1
Abstract: Valorization of argi-waste polymers into value-added materials is essential for sustainable development of polymeric industry. Reported herein is a 1-step and 2-step strategy for fabrication of flexible and stretchable thermoplastics prepared by compression molding from two structurally different arabinoxylans (AX). The synthesis was accomplished using n-butyl glycidyl ether whose epoxide ring opened on hydroxyl group and resulted in introduction of alkoxide sidechains for the 1-step synthesis. AX was preactivated by periodate oxidation as 1st step for the 2-step synthesis. Two structurally different AXs, i.e. wheat bran extracted arabinoxylan (AXWB, araf/xylp=3/4) and barley husk extracted arabinoxylan (AXBH, araf/xylp=1/4) were used to understand the effects of the araf/xylp on thermoplastic properties because melt processability has been rare for low araf/xylp AXs. AXBH-derived s les demonstrated melt compression processability. AXWB and AXBH derived thermoplastics featured dual and single glass transition (Tg) characteristics respectively as confirmed by DSC and DMA, but AXBH derived thermoplastics had lower stretchability (maximum 160%) compared to AXWB s les (maximum 300 %). Higher araf/xylp and thus in turn longer alkoxide side chains in AXWB derived thermoplastics explained differences in stretchability.
Publisher: American Chemical Society (ACS)
Date: 16-10-2020
DOI: 10.26434/CHEMRXIV.13102247.V1
Abstract: Herein we present arabinoxylan (AX)-based thermoplastics obtained by ring opening oxidation and subsequent reduction (dA-AX) combined with hydrophobization with three different glycidyl ethers [n-butyl (BuGE), isopropyl (iPrGE) and 2-ethylhexyl (EtHGE) glycidyl ether]. We also present the relationship of structural composition, thermal processing and thermomechanical properties. The BuGE and iPrGE etherified dA-AXs showed glass transition temperatures (T g ) far below their degradation temperatures and gave thermoplastic materials when compression-molded at 140˚C. The BuGE (3 mole) etherified dA-AX films at 19 and 31 % oxidation levels exclusively exhibit 244 % (±42) and 267 % (±72) elongation. In contrast, iPrGE-dA-AX s les with shorter and branched terminals in the side chains had maximum 60 % (±19) elongation. The dramatic difference in elongation is assumed to be due to the presence of longer alkoxide chains, higher molar substitution and dual T g for the BuGE s les. Such superior elongation of AX thermoplastic films and its relationship with molar substitution and T g has not been reported before.
Publisher: Elsevier BV
Date: 08-2006
DOI: 10.1016/J.BPC.2006.03.009
Abstract: The unsymmetrical cyanine dyes BOXTO-PRO and BOXTO-MEE were derived from the DNA groove binder BOXTO, by adding a positively charged or a non-ionic hydrophilic tail to BOXTO, respectively. The main objective was to obtain more efficient DNA probes, for instance in electrophoresis and microscopy, by slowing down the dissociation of BOXTO from DNA. The interactions with mixed sequence DNA was studied with fluorescence and absorbance spectroscopy, stopped-flow dissociation and gel electrophoresis. Both the derivatives are groove bound as BOXTO, and have similar fluorescence properties when bound to mixed sequence DNA in free solution. BOXTO-PRO exhibits a slower dissociation than BOXTO from DNA, whereas the dissociation rate for BOXTO-MEE is faster and, unexpectedly independent of the ionic strength. During gel electrophoresis both BOXTO-PRO and BOXTO-MEE exhibit a faster dissociation rate than BOXTO. Still, BOXTO-PRO seems to be a good alternative as DNA probe, especially for applications in free solution where the dissociation is slower than for the corresponding intercalator TOPRO-1.
Publisher: Elsevier BV
Date: 06-2011
No related grants have been discovered for Anette Larsson.