ORCID Profile
0000-0003-2662-907X
Current Organisation
Nanyang Technological University
Does something not look right? The information on this page has been harvested from data sources that may not be up to date. We continue to work with information providers to improve coverage and quality. To report an issue, use the Feedback Form.
Publisher: MDPI AG
Date: 17-02-2023
DOI: 10.20944/PREPRINTS202302.0293.V1
Abstract: The emission of black carbon (BC) particles, which cause atmospheric warming by affecting radiation budget in the atmosphere, is the result of an incomplete combustion process of organic materials. The recent wildfire event during the summer 2019-2020 in South-Eastern Australia was unprecedented in scale. The wildfires lasted for nearly 3 months over large areas of the two most populated states of New South Wales and Victoria. This study on the emission and dispersion of BC emitted from the biomass burnings of the wildfires using the Weather Research Forecast & ndash Chemistry (WRF-Chem) model is aimed to determine the extent of the BC spatial dispersion and ground concentration distribution and the effect of BC on air quality and radiative transfer at the top of the atmosphere, the atmosphere and on the ground. The predicted aerosol concentration and AOD are compared with the observed data from the New South Wales Department of Planning and Environment (DPE) aethalometer and air quality network and from remote sensing data. The BC concentration as predicted from WRF-Chem model is in general less than the observed data as measured from the aethalometer monitoring network, but the spatial pattern corresponds well, and the correlation is relatively high. The total BC emission into the atmosphere during the event and the effect on radiation budget were also estimated. This study shows that the summer 2019-2020 wildfires affect not only the air quality and health impact on the east coast of Australia but also short-term weather in the region via aerosol interactions with radiation and cloud.
Publisher: Institute of Electrical and Electronics Engineers (IEEE)
Date: 02-2020
Publisher: MDPI AG
Date: 10-04-2023
Abstract: The emission of black carbon (BC) particles, which cause atmospheric warming by affecting radiation budget in the atmosphere, is the result of an incomplete combustion process of organic materials. The recent wildfire event during the summer 2019–2020 in south-eastern Australia was unprecedented in scale. The wildfires lasted for nearly 3 months over large areas of the two most populated states of New South Wales and Victoria. This study on the emission and dispersion of BC emitted from the biomass burnings of the wildfires using the Weather Research Forecast–Chemistry (WRF–Chem) model aims to determine the extent of BC spatial dispersion and ground concentration distribution and the effect of BC on air quality and radiative transfer at the top of the atmosphere, the atmosphere and on the ground. The predicted aerosol concentration and AOD are compared with the observed data using the New South Wales Department of Planning and Environment (DPE) aethalometer and air quality network and remote sensing data. The BC concentration as predicted from the WRF–Chem model, is in general, less than the observed data as measured using the aethalometer monitoring network, but the spatial pattern corresponds well, and the correlation is relatively high. The total BC emission into the atmosphere during the event and the effect on radiation budget were also estimated. This study shows that the summer 2019–2020 wildfires affect not only the air quality and health impact on the east coast of Australia but also short-term weather in the region via aerosol interactions with radiation and clouds.
Publisher: Institute of Electrical and Electronics Engineers (IEEE)
Date: 04-2020
Publisher: Royal Society of Chemistry (RSC)
Date: 2021
DOI: 10.1039/D0NR07020C
Abstract: Hybridized surface lattice mode in an intercalated 3-disk plasmonic lattice for overcoming an inherent trade-off in plasmonic sensing.
Publisher: Wiley
Date: 04-07-2019
Publisher: MDPI AG
Date: 04-07-2019
Abstract: The ability of meteorological models to accurately characterise regional meteorology plays a crucial role in the performance of photochemical simulations of air pollution. As part of the research funded by the Australian government’s Department of the Environment Clean Air and Urban Landscape hub, this study set out to complete an intercomparison of air quality models over the Sydney region. This intercomparison would test existing modelling capabilities, identify any problems and provide the necessary validation of models in the region. The first component of the intercomparison study was to assess the ability of the models to reproduce meteorological observations, since it is a significant driver of air quality. To evaluate the meteorological component of these air quality modelling systems, seven different simulations based on varying configurations of inputs, integrations and physical parameterizations of two meteorological models (the Weather Research and Forecasting (WRF) and Conformal Cubic Atmospheric Model (CCAM)) were examined. The modelling was conducted for three periods coinciding with comprehensive air quality measurement c aigns (the Sydney Particle Studies (SPS) 1 and 2 and the Measurement of Urban, Marine and Biogenic Air (MUMBA)). The analysis focuses on meteorological variables (temperature, mixing ratio of water, wind (via wind speed and zonal wind components), precipitation and planetary boundary layer height), that are relevant to air quality. The surface meteorology simulations were evaluated against observations from seven Bureau of Meteorology (BoM) Automatic Weather Stations through composite diurnal plots, Taylor plots and paired mean bias plots. Simulated vertical profiles of temperature, mixing ratio of water and wind (via wind speed and zonal wind components) were assessed through comparison with radiosonde data from the Sydney Airport BoM site. The statistical comparisons with observations identified systematic overestimations of wind speeds that were more pronounced overnight. The temperature was well simulated, with biases generally between ±2 °C and the largest biases seen overnight (up to 4 °C). The models tend to have a drier lower atmosphere than observed, implying that better representations of soil moisture and surface moisture fluxes would improve the subsequent air quality simulations. On average the models captured local-scale meteorological features, like the sea breeze, which is a critical feature driving ozone formation in the Sydney Basin. The overall performance and model biases were generally within the recommended benchmark values (e.g., ±1 °C mean bias in temperature, ±1 g/kg mean bias of water vapour mixing ratio and ±1.5 m s−1 mean bias of wind speed) except at either end of the scale, where the bias tends to be larger. The model biases reported here are similar to those seen in other model intercomparisons.
Publisher: Institute of Electrical and Electronics Engineers (IEEE)
Date: 02-2020
Publisher: Institute of Electrical and Electronics Engineers (IEEE)
Date: 03-2006
Publisher: Institute of Electrical and Electronics Engineers (IEEE)
Date: 04-2020
Publisher: AIP Publishing
Date: 21-03-2011
DOI: 10.1063/1.3570630
Abstract: In the framework of effective mass Hamiltonian of semiconductor quantum well structures and band anticrossing model, we investigated the band structures of fully strained GaAsxP1−x−yNy/GaP quantum wells. The GaAsxP1−x−yNy could be widely modified to be direct-band gap or indirect-band gap by changing the mole fraction of As and N in the well layer. We found that an increase in the N mole fraction in the well layer increases the TE mode optical gain very slightly.
Publisher: MDPI AG
Date: 28-11-2018
DOI: 10.20944/PREPRINTS201811.0607.V1
Abstract: We propose a new technique to prepare statistically-robust benchmarking data for evaluating chemical transport model meteorology and air quality parameters within the urban boundary layer. The approach employs atmospheric class-typing, using nocturnal radon measurements to assign atmospheric mixing classes, and can be applied temporally (across the diurnal cycle), or spatially (to create angular distributions of pollutants as a top-down constraint on emissions inventories). In this study only a short (& -month) c aign is used, but grouping of the relative mixing classes based on nocturnal mean radon concentrations can be adjusted according to dataset length (i.e., number of days per category), or desired range of within-class variability. Calculating hourly distributions of observed and simulated values across diurnal composites of each class-type helps to: (i) bridge the gap between scales of simulation and observation, (ii) represent the variability associated with spatial and temporal heterogeneity of sources and meteorology without being confused by it, and (iii) provide an objective way to group results over whole diurnal cycles that separates & lsquo natural complicating factors& rsquo (synoptic non-stationarity, rainfall, mesoscale motions, extreme stability, etc.) from problems related to parameterizations, or between-model differences. We demonstrate the utility of this technique using output from a suite of seven contemporary regional forecast and chemical transport models. Meteorological model skill varied across the diurnal cycle for all models, with an additional dependence on the atmospheric mixing class that varied between models. From an air quality perspective, model skill regarding the duration and magnitude of morning and evening & rush hour& pollution events varied strongly as a function of mixing class. Model skill was typically the lowest when public exposure would have been the highest, which has important implications for assessing potential health risks in new and rapidly evolving urban regions, and also for prioritizing the areas of model improvement for future applications.
Publisher: Institute of Electrical and Electronics Engineers (IEEE)
Date: 02-2020
Publisher: MDPI AG
Date: 04-12-2019
Abstract: This paper presents a summary of the key findings of the special issue of Atmosphere on Air Quality in New South Wales and discusses the implications of the work for policy makers and in iduals. This special edition presents new air quality research in Australia undertaken by (or in association with) the Clean Air and Urban Landscapes hub, which is funded by the National Environmental Science Program on behalf of the Australian Government’s Department of the Environment and Energy. Air pollution in Australian cities is generally low, with typical concentrations of key pollutants at much lower levels than experienced in comparable cities in many other parts of the world. Australian cities do experience occasional exceedances in ozone and PM2.5 (above air pollution guidelines), as well as extreme pollution events, often as a result of bushfires, dust storms, or heatwaves. Even in the absence of extreme events, natural emissions play a significant role in influencing the Australian urban environment, due to the remoteness from large regional anthropogenic emission sources. By studying air quality in Australia, we can gain a greater understanding of the underlying atmospheric chemistry and health risks in less polluted atmospheric environments, and the health benefits of continued reduction in air pollution. These conditions may be representative of future air quality scenarios for parts of the Northern Hemisphere, as legislation and cleaner technologies reduce anthropogenic air pollution in European, American, and Asian cities. However, in many instances, current legislation regarding emissions in Australia is significantly more lax than in other developed countries, making Australia vulnerable to worsening air pollution in association with future population growth. The need to avoid complacency is highlighted by recent epidemiological research, reporting associations between air pollution and adverse health outcomes even at air pollutant concentrations that are lower than Australia’s national air quality standards. Improving air quality is expected to improve health outcomes at any pollution level, with specific benefits projected for reductions in long-term exposure to average PM2.5 concentrations.
Publisher: MDPI AG
Date: 28-02-2020
Abstract: Accurate air quality modelling is an essential tool, both for strategic assessment (regulation development for emission controls) and for short-term forecasting (enabling warnings to be issued to protect vulnerable members of society when the pollution levels are predicted to be high). Model intercomparison studies are a valuable support to this work, being useful for identifying any issues with air quality models, and benchmarking their performance against international standards, thereby increasing confidence in their predictions. This paper presents the results of a comparison study of six chemical transport models which have been used to simulate short-term hourly to 24 hourly concentrations of fine particulate matter less than and equal to 2.5 µm in diameter (PM2.5) and ozone (O3) for Sydney, Australia. Model performance was evaluated by comparison to air quality measurements made at 16 locations for O3 and 5 locations for PM2.5, during three time periods that coincided with major atmospheric composition measurement c aigns in the region. These major c aigns included daytime measurements of PM2.5 composition, and so model performance for particulate sulfate (SO42−), nitrate (NO3−), ammonium (NH4+) and elemental carbon (EC) was evaluated at one site per modelling period. Domain-wide performance of the models for hourly O3 was good, with models meeting benchmark criteria and reproducing the observed O3 production regime (based on the O3/NOx indicator) at 80% or more of the sites. Nevertheless, model performance was worse at high (and low) O3 percentiles. Domain-wide model performance for 24 h average PM2.5 was more variable, with a general tendency for the models to under-predict PM2.5 concentrations during the summer and over-predict PM2.5 concentrations in the autumn. The modelling intercomparison exercise has led to improvements in the implementation of these models for Sydney and has increased confidence in their skill at reproducing observed atmospheric composition.
No related grants have been discovered for W. J. Fan.