ORCID Profile
0000-0001-6973-1117
Current Organisation
Institute of Materials Research and Engineering
Does something not look right? The information on this page has been harvested from data sources that may not be up to date. We continue to work with information providers to improve coverage and quality. To report an issue, use the Feedback Form.
Publisher: American Chemical Society (ACS)
Date: 09-05-2016
Abstract: Lead sulfide colloidal quantum dot (CQD) solar cells demonstrate extremely high short-circuit currents (Jsc) and are making decent progress in power conversion efficiencies. However, the low fill factors (FF) and open-circuit voltages have to be addressed with urgency to prevent the stalling of efficiency improvements. This paper highlights the importance of improving hole extraction, which received much less attention as compared to the electron-accepting component of the device architecture (e.g., TiO2 or ZnO). Here, we show the use of semiconducting polymer poly(3-hexylthiophene-2,5-diyl) to create efficient CQD devices by improving hole transport, removing interfacial barriers, and minimizing shunt pathways, thus resulting in an overall improvement in device performance stemming from better Jsc and FF.
Publisher: American Chemical Society (ACS)
Date: 16-06-2020
Publisher: American Chemical Society (ACS)
Date: 07-09-2022
DOI: 10.1021/ACS.NANOLETT.2C02339
Abstract: It has been long known that low molecular weight resists can achieve a very high resolution, theoretically close to the probe diameter of the electron beam lithography (EBL) system. Despite technological improvements in EBL systems, the advances in resists have lagged behind. Here we demonstrate that a low-molecular-mass single-source precursor resist (based on cadmium(II) ethylxanthate complexed with pyridine) is capable of a achieving resolution (4 nm) that closely matches the measured probe diameter (∼3.8 nm). Energetic electrons enable the top-down radiolysis of the resist, while they provide the energy to construct the functional material from the bottom-up─unit cell by unit cell. Since this occurs only within the volume of resist exposed to primary electrons, the minimum size of the patterned features is close to the beam diameter. We speculate that angstrom-scale patterning of functional materials is possible with single-source precursor resists using an aberration-corrected electron beam writer with a spot size of ∼1 Å.
Publisher: American Chemical Society (ACS)
Date: 17-06-2014
DOI: 10.1021/CM501595U
Publisher: AIP Publishing
Date: 07-09-2015
DOI: 10.1063/1.4930144
Abstract: Multi-band gap heterojunction solar cells fabricated from a blend of 1.2 eV and 1.4 eV PbS colloidal quantum dots (CQDs) show poor device performance due to non-radiative recombination. To overcome this, a CdS shell is epitaxially formed around the PbS core using cation exchange. From steady state and transient photoluminescence measurements, we understand the nature of charge transfer between these quantum dots. Photoluminescence decay lifetimes are much longer in the PbS/CdS core/shell blend compared to PbS only, explained by a reduction in non-radiative recombination resulting from CdS surface passivation. PbS/CdS heterojunction devices sustain a higher open-circuit voltage and lower reverse saturation current as compared to PbS-only devices, implying lower recombination rates. Further device performance enhancement is attained by modifying the composition profile of the CQD species in the absorbing layer resulting in a three dimensional quantum cascade structure.
Location: United Kingdom of Great Britain and Northern Ireland
Location: Singapore
No related grants have been discovered for Darren Chi Jin Neo.