ORCID Profile
0000-0002-3560-9401
Current Organisation
Institute of Materials Research and Engineering
Does something not look right? The information on this page has been harvested from data sources that may not be up to date. We continue to work with information providers to improve coverage and quality. To report an issue, use the Feedback Form.
Publisher: Wiley
Date: 23-05-2012
Publisher: Springer Science and Business Media LLC
Date: 07-11-2009
Publisher: American Chemical Society (ACS)
Date: 09-05-2022
Abstract: It remains a challenge to directly print arbitrary three-dimensional shapes that exhibit structural colors at the micrometer scale. Woodpile photonic crystals (WPCs) fabricated
Publisher: American Chemical Society (ACS)
Date: 06-2010
DOI: 10.1021/NN100466P
Abstract: This paper reports an effective method to enhance the surface plasmon resonance (SPR) on Ag films by using a thin Ni seed layer assisted deposition. Ag films with a thickness of about 50 nm were deposited by electron beam evaporation above an ultrathin Ni seed layer of approximately 2 nm on both silicon and quartz substrates. The root-mean-square (rms) surface roughness and the correlation length have been reduced from >4 nm and 28 nm for a pure Ag film to approximately 1.3 and 19 nm for Ag/Ni films, respectively. Both experimental and simulation results show that the Ag/Ni films exhibit an enhanced SPR over the pure Ag film with a narrower full width at half-maximum. Ag films with a Ge seed layer have also been prepared under the same conditions. The surface roughness can be reduced to less than 0.7 nm, but narrowing of the SPR curve is not observed due to increased absorptive d ing in the Ge seed layer. Our results show that Ni acts as a roughness-diminishing growth layer for the Ag film while at the same time maintaining and enhancing the plasmonic properties of the combined structures. This points toward its use for low-loss plasmonic devices and optical metamaterials applications.
Publisher: Wiley
Date: 22-11-2022
Abstract: Metasurfaces supporting optical bound states in the continuum (BICs) are emerging as simple and compact optical cavities to realize polarization-vortex lasers. The winding of the polarization around the singularity defines topological charges which are generally set by the cavity design and cannot be altered without changing geometrical parameters. Here, a subwavelength-thin phase-change halide perovskite BIC metasurface functioning as a tunable polarization vortex microlaser is demonstrated. Upon the perovskite structural phase transitions, both its refractive index and gain vary substantially, inducing reversible and bistable switching between distinct polarization vortexes underpinned by opposite topological charges. Dynamic tuning and switching of the resulting vector beams may find use in microscopy imaging, particle trapping and manipulation, and optical data storage.
Publisher: Wiley
Date: 19-09-2015
Publisher: Springer Science and Business Media LLC
Date: 04-12-2009
Publisher: Wiley
Date: 06-04-2017
Publisher: American Chemical Society (ACS)
Date: 06-03-2012
DOI: 10.1021/NL2044088
Abstract: Photolithography is the technology of choice for mass patterning in semiconductor and data storage industries. Superlenses have demonstrated the capability of subdiffraction-limit imaging and been envisioned as a promising technology for potential nanophotolithography. Unfortunately, subdiffraction-limit patterns generated by current superlenses exhibited poor profile depth far below the requirement for photolithography. Here, we report an experimental demonstration of sub-50 nm resolution nanophotolithography via a smooth silver superlens with a high aspect profile of ~45 nm, as well as grayscale subdiffraction-limit three-dimensional nanopatterning. Theoretical analysis and simulation show that smooth interfaces play a critical role. Superlens-based lithography can be integrated with conventional UV photolithography systems to endow them with the capability of nanophotolithography, which could provide a cost-effective approach for large scale and rapid nanopatterning.
Publisher: Wiley
Date: 14-02-2022
Abstract: The Rashba effect, i.e., the splitting of electronic spin‐polarized bands in the momentum space of a crystal with broken inversion symmetry, has enabled the realization of spin‐orbitronic devices, in which spins are manipulated by spin–orbit coupling. In optics, where the helicity of light polarization represents the spin degree of freedom for spin–momentum coupling, the optical Rashba effect is manifested by the splitting of optical states with opposite chirality in the momentum space. Previous realizations of the optical Rashba effect relied on passive devices determining the surface plasmon or light propagation inside nanostructures, or the directional emission of chiral luminescence when hybridized with light‐emitting media. An active device underpinned by the optical Rashba effect is demonstrated here, in which a monolithic halide perovskite metasurface emits highly directional chiral photoluminescence. An all‐dielectric metasurface design with broken in‐plane inversion symmetry is directly embossed into the high‐refractive‐index, light‐emitting perovskite film, yielding a degree of circular polarization of photoluminescence of 60% at room temperature.
Publisher: Springer Science and Business Media LLC
Date: 21-10-2019
DOI: 10.1038/S41467-019-12637-0
Abstract: Metasurfaces as artificially nanostructured interfaces hold significant potential for multi-functionality, which may play a pivotal role in the next-generation compact nano-devices. The majority of multi-tasked metasurfaces encode or encrypt multi-information either into the carefully tailored metasurfaces or in pre-set complex incident beam arrays. Here, we propose and demonstrate a multi-momentum transformation metasurface (i.e., meta-transformer), by fully synergizing intrinsic properties of light, e.g., orbital angular momentum (OAM) and linear momentum (LM), with a fixed phase profile imparted by a metasurface. The OAM meta-transformer reconstructs different topologically charged beams into on-axis distinct patterns in the same plane. The LM meta-transformer converts red, green and blue illuminations to the on-axis images of “R”, “G” and “B” as well as vivid color holograms, respectively. Thanks to the infinite states of light-metasurface phase combinations, such ultra-compact meta-transformer has potential in information storage, nanophotonics, optical integration and optical encryption.
No related grants have been discovered for Hong Liu.