ORCID Profile
0000-0001-6135-0272
Current Organisation
University of South Australia
Does something not look right? The information on this page has been harvested from data sources that may not be up to date. We continue to work with information providers to improve coverage and quality. To report an issue, use the Feedback Form.
Publisher: Elsevier BV
Date: 12-2021
Publisher: MDPI AG
Date: 24-08-2021
DOI: 10.3390/SU13179521
Abstract: Impact resistance, water transport properties and sodium sulphate attack are important criteria to determine the performance of concrete incorporating mixed types of recycled plastic waste. Nine mixes were designed with different combinations of the three plastic types Polyethylene terephthalate (PET), High density polyethylene (HDPE) and Polypropylene (PP). The plastic partially substituted the coarse aggregate (by volume) at various replacement ratios 10%, 15%, 20% and 30%. The impact resistance and water transport properties were evaluated for nine mixes while sodium sulphate attack test was performed for three mixes. The results showed that the addition of mixed recycled plastic in concrete improved the impact resistance. The highest impact resistance improvement was achieved by R8 (PET + HDPE + PP) at 30% replacement which was 4.5 times better than the control mix. Water absorption results indicated a slight increase in all plastic mixes while contradictory results were observed for sorptivity test. Analysis of sodium sulphate attack results showed that incorporating 30% mixed plastic reduced the sodium sulphate resistance slightly due to the collective effect of plastic entrapping of sulphate ions after 80 cycles. This study has shown some positive results relating to the impact performance of Mixed Recycled Plastic Concrete (MRPC) which enhances its use in a sustainable way.
Publisher: Elsevier BV
Date: 02-2022
Publisher: MDPI AG
Date: 30-05-2021
DOI: 10.3390/JCS5060146
Abstract: Different types of recycled plastic have been used in concrete and most studies have focused on the behaviour of a single type of plastic. However, separating plastic wastes increases the cost and time of processing. To tackle this problem, this research presents an experimental investigation to determine the effect of incorporating different combinations of three types of recycled plastic waste aggregates—Polyethylene terephthalate (PET), High Density Polyethylene (HDPE) and Polypropylene (PP)—at different replacement ratios of coarse aggregate on physical and mechanical properties of concrete. The combinations include two plastic types at 10% and 20% replacement ratios and three plastic types at 15% and 30% replacement ratios. The performance of the plastic concrete was assessed based on various physical and mechanical properties including workability, fresh and dry densities, air content, compressive, indirect tensile and flexural strengths, modulus of elasticity, stress-strain behaviour and ultrasonic pulse velocity. It is found that the workability of Mixed Recycled Plastic Concrete (MRPC) at a low replacement rate is independent of the type of plastic. The minimum reduction in the compressive strength, indirect tensile and modulus of elasticity were achieved by R3 (PET + PP) at 10% replacement, while R5 (HDPE + PP) at 10% replacement achieved the highest flexural strength and ultrasonic pulse velocity values. The findings suggest that the mixed recycled plastics have a good possibility to partially replace coarse aggregates in concrete which will benefit the plastics recycling community and environment. Furthermore, the study will provide guidance to the concrete industry concerning the effect of the implementation of unsorted mixed types of plastic as coarse aggregates in the production of concrete.
Publisher: Elsevier BV
Date: 07-2021
No related grants have been discovered for Mark Ellis.