ORCID Profile
0000-0003-4119-3198
Current Organisations
University of Technology Sydney
,
Royal Botanic Garden Sydney
,
University of Technology Sydney Faculty of Engineering and Information Technology
Does something not look right? The information on this page has been harvested from data sources that may not be up to date. We continue to work with information providers to improve coverage and quality. To report an issue, use the Feedback Form.
In Research Link Australia (RLA), "Research Topics" refer to ANZSRC FOR and SEO codes. These topics are either sourced from ANZSRC FOR and SEO codes listed in researchers' related grants or generated by a large language model (LLM) based on their publications.
Environmental Engineering | Environmental Technologies | Fertilisers and Agrochemicals (Application etc.)
Publisher: Elsevier BV
Date: 08-2013
DOI: 10.1016/J.WATRES.2012.12.045
Abstract: In this study, Degussa P25 TiO2 was partially dissolved in a mixture of hydrogen peroxide and sodium hydroxide at high pH. The fabrication of nanofibres proceeded by the hydrothermal treatment of the solution at 80 °C. This was followed by acid wash in HCl at pH 2 for 60 min, which resulted in the formation of hydrogen-titanate nanofibres. The nanofibres were annealed at 550 °C for 6 h to produce crystalline anatase nanofibres. The nanofibres were characterised for physico-chemical modifications and tested for the adsorption and photocatalytic degradation of methylene blue as a model water pollutant. An average specific surface area of 31.54 m(2)/g, average pore volume of 0.10 cm(3)/g and average pore size of 50 Å were recorded. The nanofibres were effective adsorbents of the model pollutant and adsorbents and good photocatalysts under simulated solar light illumination. No reduction in photocatalytic activity was observed over three complete treatment cycles, and the effective separation of nanofibres was achieved by gravity settling resulting in low residual solution turbidity.
Publisher: American Scientific Publishers
Date: 06-2013
Abstract: The main drawback of flocculation process with dye wastewater is the large amount of unrecyclable sludge which needs disposal. A novel process using Ti-salt flocculation to purify wastewater was developed to produced sludge that can be calcined to produce titania. In this study, iron-doped TiO2 nanomaterial was successfully produced from sludge obtained by the flocculation of dye wastewater with a composite floculant including TiCl4 and FeSO4. The titania was characterised using scanning electron microscopy (SEM/EDX), transmission electron microscopy (TEM), X-ray diffraction (XRD), and the photodecomposition of acetaldehyde. The XDR results showed that the anatase and rutile structures were found after sludge calcination at 550 degrees C and 640 degrees C respectively. The elemental analyses were carried out using EDX. The rutile titania s le consisted of Ti (35.7 wt.%), Fe (14.7 wt.%), O (42.3 wt.%), P (2.6 wt.%) and Ca (4.7 wt.%). The photocatalytic activity was monitored for the photodecomposition of gas acetaldehyde. Iron-doped titania seems to play an important role in increasing the photocatalytic activity under UV light irradiation.
Publisher: American Scientific Publishers
Date: 08-2011
Abstract: In this study, the removal of phosphorous (P) using Ti-salt flocculation of biologically treated sewage effluent (BTSE) was investigated for a year. The pH, alkalinity and concentration of P, before and after Ti-salt flocculation, were measured and compared. The sludge of Ti-salt flocculation was incinerated at 600 degrees C to produce titania nanoparticles which found to be doped with P Titania nanoparticles were characterised and their photocatalytic activity under UV light irradiation were also tested. Results indicated that the removal of P, which exceeded 97% in average, was not affected by the pH and the alkalinity of BTSE. The concentration of P in titania had no effect on the characteristics of titania nanoparticles in different seasons. Titania nanoparticles exhibited superior properties in terms of BET surface area and photocatalytic activity.
Publisher: Elsevier BV
Date: 02-2011
Publisher: Elsevier BV
Date: 04-2011
Publisher: American Scientific Publishers
Date: 07-2015
Abstract: In the past few years, silica-modified titania has drawn increasing attention due to their special properties making them ideal candidates for a wide range of applications. In this study, we report a novel method for the synthesis of silica-modified titania by a sol-gel method using sodium silicate solution (1 M). The hydrolysis and condensation reactions of titanium dioxide (TiO2, Degussa Aeroxide® P25) in sodium silicate solution proceeded with citric acid (3 M) as a catalyst. The orbital shaking method was followed for the removal of sodium salt formed during the sol-gel process. Solvent exchange was carried out using methanol and hexane. Finally, chemical modification of the gel was conducted using trimethylchlorosilane followed by ambient pressure drying. The obtained silica-modified titania was characterised for nanostructural analysis using scanning electron microscopy and transmission electron microscopy. The nitrogen adsorption-desorption measurements were employed to investigate the BET surface area, pore structure and pore volume of specimens. Thermal gravimetric analysis showed exothermic peaks at temperature range of 90-190 °C representing the oxidation of organic groups from--Si-R network. The silica-modified titania showed high photocatalytic activity and an easy recovery using crystal violet as model water pollutant.
Publisher: Elsevier BV
Date: 06-2017
Publisher: Wiley
Date: 19-10-2010
DOI: 10.1002/JSFA.4191
Abstract: The potential of Origanum syriacum L. to become a cultivated crop in Lebanon rather than being harvested from the wild was investigated at the production, postharvest and economic levels. Three irrigation schemes were tested on growth parameters of cultivated oregano plants. In order to identify the most quality-preserving drying technique, air-, oven (30 °C)- and freeze-dried oregano s les were assessed through sensory analysis. Cost/benefit analysis was used to compare the economic potential of O. syriacum in four production scenarios. An irrigation scheme of 16 L per plant administered every 2 weeks (medium irrigation) during the dry period resulted in a doubling of the horticultural (56.34%) and hydro-distilled essential oil (55.22%) yields. Descriptive sensory analysis showed that air-dried material had the desired flavour, aroma and colour attributes. Net present values ranged from - 677 406.02 to 562 301.5 US$ and benefit/cost ratios from 0.5341 to 5.1993 for a 1 ha, 5 year life-cycle oregano farm. Irrigating plants once every 2 weeks during the dry season optimised herbage and essential oil yields of oregano, while air drying of plant material preserved its organoleptic attributes as a spice. Three of the four production scenarios, namely Zaatar production, herbal tea and Zaatar production and essential oil production, were economically feasible, with the last of these having the highest economic feasibility.
Publisher: American Chemical Society (ACS)
Date: 26-03-2012
DOI: 10.1021/ES300002W
Abstract: In fertilizer-drawn forward osmosis (FDFO) desalination, the final nutrient concentration (nitrogen, phosphorus, potassium (NPK)) in the product water is essential for direct fertigation and to avoid over fertilization. Our study with 11 selected fertilizers indicate that blending of two or more single fertilizers as draw solution (DS) can achieve significantly lower nutrient concentration in the FDFO product water rather than using single fertilizer alone. For ex le, blending KCl and NH(4)H(2)PO(4) as DS can result in 0.61/1.35/1.70 g/L of N/P/K, which is comparatively lower than using them in idually as DS. The nutrient composition and concentration in the final FDFO product water can also be adjusted by selecting low nutrient fertilizers containing complementary nutrients and in different ratios to produce prescription mixtures. However, blending fertilizers generally resulted in slightly reduced bulk osmotic pressure and water flux in comparison to the sum of the osmotic pressures and water fluxes of the two in idual DSs as used alone. The performance ratio or PR (ratio of actual water flux to theoretical water flux) of blended fertilizer DS was observed to be between the PR of the two fertilizer solutions tested in idually. In some cases, such as urea, blending also resulted in significant reduction in N nutrient loss by reverse diffusion in presence of other fertilizer species.
Publisher: American Scientific Publishers
Date: 05-2016
Abstract: Solar photocatalytic degradation of organic water pollutants can be used to degrade toxic organic pollutants in water. In this study, potassium titanate nanofibres were synthesized by an aqueous peroxide route at high pH and examined as photocatalysts for photodegradation of methylene blue (MB) using a solar simulator. Initially, MB was adsorbed on the surface of potassium polytitanates to achieve adsorption equilibrium before the photocatalysts were illuminated using solar simulator. The results showed that potassium polytitanate nanofibres were effective adsorbents of MB and also facilitated its photocatalytic degradation. Sulphate ion evolution during photocatalysis confirmed that some mineralisation occurred and hence photo-oxidative degradation of MB took place. The optimum operational conditions for the photocatalytic degradation of MB were found at 0.05 g/L of photocatalyst load, 10 mg/L MB and pH 7. The stability and regeneration of the photocatalyst specimen was also studied for 3 degradation cycles using adsorption hotocatalysis model. Morphological structure analysis of potassium titanate showed nanocrystallines structure of longitudinally-oriented isolated fibre with a length up to several micrometres with diameters ranging from 10 to 20 nanometres.
Publisher: Elsevier BV
Date: 10-2020
Publisher: Sycamore Global Publications
Date: 2010
Abstract: Producing a useful catalyst (TiO
Publisher: Elsevier BV
Date: 11-2014
DOI: 10.1016/J.JES.2014.09.020
Abstract: Potassium titanate nanostructures were synthesised by hydrothermal treatment of TiO2 (P25) in KOH and H2O2. As-produced powders were characterised by scanning electron microscopy, energy-dispersive X-ray spectroscopy, transmission electron microscopy, X-ray diffraction, and nitrogen adsorption-desorption methods. Longitudinally-oriented-wire-like structures with a length up to several micrometres and diameters ranging from 10 to 30 nm were obtained. Larger size fibrous nanowires resulting from the hydrothermal treatment showed high affinity in adsorbing crystal violet (CV), which was mainly due to their high surface area. The photocatalytic bleaching of CV solution revealed that the wires are photoactive under ultraviolet light irradiation. Macroporous nanowires are considered as effective adsorbents of CV, capable of photocatalytic degradation, and they can be easily separated from the solution by settling.
Publisher: Elsevier BV
Date: 10-2009
Publisher: Elsevier BV
Date: 2014
Publisher: Sycamore Global Publications
Date: 2009
Abstract: In this study, the effect of washing TiO
Publisher: American Scientific Publishers
Date: 02-2016
Abstract: Potassium polytitanate nanofibres prepared by a hydrothermal method were investigated for their possible application in removing toxic metals from aqueous solution. Particular attention was paid to employing the titanate as a novel effective adsorbent for the removal of Pb(II). Batch adsorption experiments demonstrated that the adsorption was influenced by various conditions such as solution pH, adsorbent dosage and initial Pb(II) concentration. The results showed that the adsorption rate was faster in the first 5 min and equilibrium was achieved after 180 min. The maximum amount of adsorption was detected at pH 5. Potassium titanate showed much higher adsorption capacity compared to P25. The kinetic studies indicated that the adsorption of Pb(II) onto titanate best fit the pseudo-second-order kinetic model. FTIR spectra revealed that the hydroxyl groups in titanate were responsible for Pb(II) adsorption. The principal mechanism of the adsorption of Pb(II) in the present study is attributed to both ion exchange and oxygen bonding. The adsorption-desorption results demonstrated that the titanate could be readily regenerated after adsorption. Therefore, the present titanate exhibits great potential for the removal of Pb(II) from wastewater.
Publisher: Informa UK Limited
Date: 08-08-2014
Publisher: American Society of Civil Engineers
Date: 27-06-2016
Publisher: IWA Publishing
Date: 06-2009
DOI: 10.2166/WST.2009.254
Abstract: Flocculation with titanium tetrachloride (TiCl4) and titanium sulfate (Ti(SO4)2) was investigated in terms of different coagulant doses, pH, turbidity, dissolved organic carbon (DOC), UV-254, colour, zeta potential, particle size and molecular weight distribution. The two coagulants were compared with the commonly used coagulants such as ferric chloride (FeCl3) and aluminium sulfate (Al2(SO4)3). Titanium tetrachloride showed the highest turbidity removal, while titanium sulfate showed the highest reduction of UV-254 and colour at all pH values. The four coagulants were found to have similar organic removal up to 60–67% and resulted in similar organic removal in terms of various MW ranges. The decantability of the settled flocs was very high for titanium tetrachloride, titanium sulfate and ferric chloride compared with aluminium sulfate. The dominating coagulation mechanisms for titanium tetrachloride and titanium sulfate are still to be studied, since different precipitation reactions might take place at different pH even without flocculant addition. Titanium tetrachloride and titanium sulfate were found as effective new coagulants in wastewater treatment not only in terms of organic matter removal, but also in sludge reduction through the production of titanium dioxide.
Publisher: Elsevier BV
Date: 03-2011
Publisher: Informa UK Limited
Date: 04-11-2015
Publisher: Elsevier BV
Date: 05-2012
Publisher: Elsevier BV
Date: 09-2012
Publisher: Asian Pacific Journal of Tropical Medicine Press
Date: 07-06-2017
Location: Australia
Start Date: 07-2022
End Date: 07-2026
Amount: $2,062,428.00
Funder: Australian Research Council
View Funded Activity