ORCID Profile
0000-0003-1078-7698
Current Organisation
University of Tasmania
Does something not look right? The information on this page has been harvested from data sources that may not be up to date. We continue to work with information providers to improve coverage and quality. To report an issue, use the Feedback Form.
Publisher: Elsevier BV
Date: 05-2022
Publisher: MDPI AG
Date: 28-08-2022
DOI: 10.3390/EN15176282
Abstract: Over many decades, isolated regions (e.g., islands, rural and remote areas) have heavily relied on diesel engine for producing power and energy. However, due to depleting fossil fuels and concerning emissions, biodiesels could be the substitute for diesel in power generation sectors. This study developed a single-zone thermodynamic model to predict the engine performances such as brake power (BP), torque, brake thermal efficiency (BTE), brake-specific fuel consumption (BSFC) and ignition delay (ID) times for diesel and jojoba biodiesel. The experiments were conducted on a fully automated, 4-cylinder, 4-stroke, liquid-cooled direct injection 3.7-L diesel engine fueled with diesel (D100) and three jojoba blends (JB5, JB10, and JB20) to validate the model. The performance simulation results agreed with experimental data for all tested fuels at 1200 to 2400 rpm speed and 25%, 50%, 75%, and 100% loading operation. The minimum error (3.7%) was observed for BP for D100 at 2000 rpm and 100% load, and the maximum error (19.2%) was found for JB10 at 1200 rpm and 25% loading operation. As load increases from 25 to 100%, the BSFC and torque difference between diesel and JB20 decreases from 10 to 6.5 and 9 to 6%, respectively. A shorter ID time was observed in JB5 compared to JB10 and JB20. Furthermore, a significant reduction was observed in CO (7.55%) and HC (6.65%) emission for JB20 at 25% and 1200 rpm compared to diesel fuel however, NOx emission was increased up to 10.25% under any given conditions.
Publisher: Informa UK Limited
Date: 11-07-2015
Publisher: IEEE
Date: 05-2014
Publisher: Elsevier BV
Date: 06-2022
Publisher: Informa UK Limited
Date: 10-11-2016
Publisher: Informa UK Limited
Date: 03-06-2015
Publisher: IOP Publishing
Date: 08-2021
DOI: 10.1088/1755-1315/838/1/012013
Abstract: Diesel engine is using prominently in islands and remote areas due to its reliability and stability for power generation. In recent years, most of the isolated power systems (e.g., islands and remote areas) have integrated renewable energies to reduce both the cost and pollution in diesel power generating system. However, due to intermittent and stochastic behaviour of renewable sources (e.g., solar and wind), it is unable to eliminate diesel generation entirely. In that case, low-load diesel operation (operation 30% of maximum rated load) is particularly relevant for its ability to support higher levels of renewable penetration. In this paper, a thermodynamic model was developed using MATLAB for diesel engine combustion and performance. This model includes sub models such as heat release rate, heat transfer, double-Wiebe function, and ignition delay correlation. Engine thermal efficiency (TE), brake power (BP), indicated mean effective pressure (IMEP) and brake specific fuel consumption (BSFC) has been taken into consideration for performance analysis. The simulation results show that at 25% load, in-cylinder pressure and temperature are 168 bar and 2300 K which are the cause of lower heat release rate (74 J/deg) and longer ignition delay (0.25 ∼0.5 ms higher than that of conventional mode) and significantly responsible for lower efficiency (18%), brake power (4kW) and higher brake specific fuel consumption (1.2 g/kWh).
Publisher: MDPI AG
Date: 25-06-2022
DOI: 10.3390/EN15134667
Abstract: This study investigated the suitability of stone fruit seed as a source of biodiesel for transport. Stone fruit oil (SFO) was extracted from the seed and converted into biodiesel. The biodiesel yield of 95.75% was produced using the alkaline catalysed transesterification process with a methanol-to-oil molar ratio of 6:1, KOH catalyst concentration of 0.5 wt% (weight %), and a reaction temperature of 55 °C for 60 min. The physicochemical properties of the produced biodiesel were determined and found to be the closest match of standard diesel. The engine performance, emissions and combustion behaviour of a four-cylinder diesel engine fuelled with SFO biodiesel blends of 5%, 10% and 20% with diesel, v/v basis, were tested. The testing was performed at 100% engine load with speed ranging from 200 to 2400 rpm. The average brake specific fuel consumption and brake thermal efficiency of SFO blends were found to be 4.7% to 15.4% higher and 3.9% to 11.4% lower than those of diesel, respectively. The results also revealed that SFO biodiesel blends have marginally lower in-cylinder pressure and a higher heat release rate compared to diesel. The mass fraction burned results of SFO biodiesel blends were found to be slightly faster than those of diesel. The SFO biodiesel 5% blend produced about 1.9% higher NOx emissions and 17.4% lower unburnt HC with 23.4% lower particulate matter (PM) compared to diesel fuel. To summarise, SFO biodiesel blends are recommended as a suitable transport fuel for addressing engine emissions problems and improving combustion performance with a marginal sacrifice of engine efficiency.
Publisher: Elsevier BV
Date: 06-2014
No related grants have been discovered for A G M Mustayen Billah.