ORCID Profile
0000-0002-8171-6291
Current Organisation
Deakin University
Does something not look right? The information on this page has been harvested from data sources that may not be up to date. We continue to work with information providers to improve coverage and quality. To report an issue, use the Feedback Form.
Publisher: Elsevier BV
Date: 2016
Publisher: Springer Science and Business Media LLC
Date: 17-11-2011
DOI: 10.1557/JMR.2011.333
Publisher: Elsevier BV
Date: 11-2015
Publisher: Springer Science and Business Media LLC
Date: 11-02-2015
Publisher: Elsevier BV
Date: 06-2014
Publisher: Elsevier BV
Date: 10-2013
Publisher: Springer Science and Business Media LLC
Date: 04-01-2015
Publisher: Elsevier BV
Date: 2013
Publisher: Elsevier BV
Date: 10-2013
Publisher: Elsevier BV
Date: 11-2010
Publisher: Elsevier BV
Date: 11-2015
Publisher: Elsevier BV
Date: 10-2015
Publisher: Elsevier BV
Date: 2017
Publisher: Springer Science and Business Media LLC
Date: 02-10-2014
DOI: 10.1007/S11661-014-2579-4
Abstract: Development of the methodology for creating reliable digital material representation (DMR) models of dual-phase steels and investigation of influence of the martensite volume fraction on fracture behavior under tensile load are the main goals of the paper. First, an approach based on image processing algorithms for creating a DMR is described. Then, obtained digital microstructures are used as input for the numerical model of deformation, which takes into account mechanisms of ductile fracture. Ferrite and martensite material model parameters are evaluated on the basis of micropillar compression tests. Finally, the model is used to investigate the impact of the martensite volume fraction on the DP steel behavior under plastic deformation. Results of calculations are presented and discussed in the paper.
Publisher: Elsevier BV
Date: 06-2017
Publisher: Elsevier BV
Date: 05-2013
Publisher: International Union of Crystallography (IUCr)
Date: 29-09-2016
DOI: 10.1107/S1600576716013054
Abstract: A series of three steel alloys with increasing Cu and S concentrations has been prepared by simulated direct strip casting. It was found that the rapid solidification that occurs during direct strip casting results in the formation of a high number density of fine MnS precipitates, while Cu was retained in solid solution above equilibrium concentration. Upon ageing the MnS particles were found to coarsen and increase in volume fraction, indicating that some S was retained in solid solution in the as-cast condition. Ageing also resulted in the precipitation of Cu-rich precipitates. A new method to determine precipitate composition from small-angle neutron scattering is presented. This methodology, in conjunction with atom-probe tomography, has been used to show that the composition of the Cu-rich precipitates depends on the alloy's bulk Cu content.
Publisher: Elsevier BV
Date: 12-2017
Publisher: Elsevier BV
Date: 12-2014
Publisher: Elsevier BV
Date: 2019
Publisher: Elsevier BV
Date: 05-2009
Publisher: Elsevier BV
Date: 2016
Publisher: Elsevier BV
Date: 12-2016
Publisher: Elsevier BV
Date: 06-2008
Publisher: Trans Tech Publications Ltd.
Date: 09-02-2008
Publisher: Elsevier BV
Date: 03-2018
No related grants have been discovered for Jiangting Wang.